quadra trac help required

[Brick]

hey guys
was under my cj today and found the vacumn lines for the quadra trac were hanging freely

was wondering if anyone can tell me which hose goes where there are only two hoses near the tranfer case just wondering if where the hoses connect to the case if there should be suchion at the closest connecton to the front or the rear when the switch is in normal drive mode

dont want to drive around with it in emergancy drive

oh and the light on the dash does not work to tell me if it on

cheers guys

[ian]

ok to tell if it is locked in emergancy drive just jack up one wheel and it should spin and the jeep should go know where, Put the lines one and ude the swich and see if you can get it to lock in and out with the wheel up. I had to do the same thing.. o ya I would use a trolly jack with wheels!

[Glenn]

ok to tell if it is locked in emergancy drive just jack up one wheel and it should spin and the jeep should go know where, Put the lines one and ude the swich and see if you can get it to lock in and out with the wheel up. I had to do the same thing.. o ya I would use a trolly jack with wheels!
I thought the quadratrac was limited slip so even unlocked it would still try to drive along with one wheel jacked up.

[JRock]

Hi Brick. If you go to

http://www.frontier.net/~mystkblu/quadratrac/

there will be a lot of info on the Qtrac including a diagram which shows which way the air hoses connect so you can re-connect everything.

Cheers,

JROCK

[TW.]

yep, that link sais it all.....