|
View Full Version : Drilled Side View Mirrors JK07 21-11-2007, 07:24 PM Everytime I wash the jeep the mirrors drip water for days and leave spots all over the side of the door :wall: Found the solution on Jk forum here it is Just drill a hole just underneath the mirror and its done :D Tiny 21-11-2007, 09:35 PM i find sitting it in 30+degee sun sorts that out as well Devilish 21-11-2007, 10:03 PM i have been planning to do this for about 6 months... i just can't remember where the hell my drill is.... Tiny 21-11-2007, 10:08 PM didnt you use it for stirring on another thread? Devilish 21-11-2007, 10:15 PM nah, that was the circular saw.... always know where that baby is! haha SharpWraX 05-01-2008, 11:32 AM This prob is also driving me crazy. Did this drilling really work? ksk 05-01-2008, 12:12 PM Thats ridicoulous, doesnt this stuff get tested?..jeeeez.. KSK Jk2Door 05-01-2008, 02:15 PM if you dont want to leave a hole in the mirror take the mirror off by unbolting it from inside the door and inside there will be a pre existing drain hole, just enlarge with a file and snip out a little piece of the foam gasket. if it doesnt work cut a bit more gasket, save using a drill and putting a hole where one already exists. :) davidd 05-01-2008, 02:43 PM nah, that was the circular saw.... always know where that baby is! haha ah!!! definitely a brother in arms... i have a distinct prefernce for a four inch angle grinder. fixes anything. vBulletin® v3.8.7, Copyright ©2000-2013, vBulletin Solutions, Inc.
|
