loric
08-02-2010, 03:19 PM
Maybe a silly question - but if you trim the upper ball joint 'bolt/stud' in order to fit larger tyres - does this make future steering knuckle removal/installation harder?
The bit you trim off is the bit that you hold with a shifter to stop the UBJ stud rotating when you tighten the UBJ nut. I suppose you could somehow clamp the UBJ into the knuckle to get the wedge fit, or hold the remainder of the stud with vise-grips, but then you'd stuff the thread up.
Any thoughts on this?
The bit you trim off is the bit that you hold with a shifter to stop the UBJ stud rotating when you tighten the UBJ nut. I suppose you could somehow clamp the UBJ into the knuckle to get the wedge fit, or hold the remainder of the stud with vise-grips, but then you'd stuff the thread up.
Any thoughts on this?