|
Front diff bushes and replaced the trans electrical connector trying to stop the leak.
Bushes where fun.... https://uploads.tapatalk-cdn.com/201...9b42aa1c9e.jpghttps://uploads.tapatalk-cdn.com/201...3b7071804b.jpghttps://uploads.tapatalk-cdn.com/201...b6dd290aa2.jpg Sent from my SM-G930F using Tapatalk |
Quote:
On the front im running 1 inch hubcentric spacers, but the rims fit without any. I like the little bit of poke for front fender protection when in deep ruts There aren't any spacers on the rear. |
Started the hunt for my front end bearing noise, seems that neither of the front bearings have play in them from what I can see so the search continues!
|
Quote:
Next time just cut through the rubber and outer steel ring using a reciprocating saw (careful not to hit the aluminium, I cut it a fraction short and hit the steel flange with a cold chisel to 'crack' the cut.), then it'll pop out with a few whacks. |
I cut it out with a Hacksaw doing what you said. Cold chisel had it out soon after.
Sent from my SM-G930F using Tapatalk |
Quote:
Once i got the old one out it seemed ok expect for a faint notch while turning it. |
Spent the last hour looking for the engine number on my CRD for a Blue slip tomorrow.
Cant find jack and Google is not very helpful. Anybody know where the hell it is? |
All times are GMT +10. The time now is 08:22 AM. |
|
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
AJOR © 2002 - 2024 AUSJEEPOFFROAD.COM. All corporate trademarked names and logos are property of their respective owners. Ausjeepoffroad is in no way associated with DaimlerChrysler Corporation or Fiat Jeep.
www.ausjeep.com www.ausjeep.com.au www.midlifemate.com ausjeepforum.com www.r9kustoms.com