Number plate mount position?
 

Hi All,

I fitted a second ARB bar to the front of my TJ.

Where have others mounted their number plates and how? Have you use a special bracket, drilled holes, flip-able cover over winch hole?

Thanks in advance,
Brad

While I have your attention, anybody ever bought one of these?
http://www.tigerz11.com.au/product-c...h-dyneema.html

I get emails from this bunch all the time. Ive read mixed reviews, most complaints are on servicing. My question is more so around how well they perform for the $$$ you spend?

i had mine mounted below the fairleed hole but kept ripping it off so i wedged it in my windscreen rubber inside the cab with intentions of later tec screwing it to the front on the passenger side of the fairleed hole but never ended up doing it

I had the same issue with my RR XHD front bar, so bought a fairlead roller (even though I don't have a winch) - this fairlead also has holes to mount spotties :)
http://www.jeep4x4center.com/rugged-...-11238-03.html
http://www.ausjeepoffroad.com/forum/...0&d=1376350309

Then got a clip on license plate mount
http://www.jeep4x4center.com/rugged-...-11238-05.html
http://www.ausjeepoffroad.com/forum/...1&d=1376350309

Here's a pic on my TJ \/ \/

http://www.ausjeepoffroad.com/forum/...2&d=1376350770

Probably overkill, but I attached it with some wire thread in case it fell off - this was not necessary as the clips on the rollers are very, very firm. But I suppose the wires would deter theft as well.

http://www.ausjeepoffroad.com/forum/...0&d=1319840193

Number plate mount position?
 

I put a few screws here when i had one. Just had to bend the plate slightly.

http://i1237.photobucket.com/albums/...s/IMG_0919.jpg

Are there no issues with bending the plate? Just wondering if anyone has had issues with police with that?

Number plate mount position?
 

Its only a slight bend. Ive been pulled over a few times with it like that and nothing was said. Technically there may be an issue but its very low on the priority list.