Thank you for my fix, I was getting withdrawal symptoms! Love ya work as usual.


Sent from my iPad using Tapatalk

Ha ha, I'm glad to oblige! ;)

All I can do is smile and nod, Markus...

Love it mate......

Fiddly stage to be at but better than leaving them all until last which most do and have months of doing this type of jobs!

http://willyshotrod.com/Willys1236.jpg
Now you see the latch in place behind the window channel. Problem to solve now is to connect the door handle at the top right to the latch link on the left, without going in front of the window channel where the glass will run in.

http://willyshotrod.com/Willys1237.jpg
Top view shows it a bit better maybe. Can make out the door handle link attachment on the bottom right which has to connect to the gold lever coming off the top of the latch. Cannot go in front of the window channel.

http://willyshotrod.com/Willys1238.jpg
I thought I would build a hinge to go behind the window channel. Just using some 35mm SHS for the support and the hinge pin made from a 8mm bolt.

http://willyshotrod.com/Willys1239.jpg
Made some arms for the hinge from 20x3mm flat steel. I drilled them all the same to match link positions as gives me the option of a ratio change if needed.

http://willyshotrod.com/Willys1241.jpg
I welded the arms to the pivot ends and have a 21* difference in them so one end sat low enough below the door handle.

http://willyshotrod.com/Willys1242.jpg
Also put a dog leg on the door handle side to get it to line up better.

http://willyshotrod.com/Willys1243.jpg
Rather than having more bolts attaching the hinge to the inside of the door, or welding it in permanently, I welded it to the top of the latch housing.

http://willyshotrod.com/Willys1244.jpg
Made up a short link to connect one arm to the latch lever.

http://willyshotrod.com/Willys1245.jpg
Here you can see it in place. Rather than go all the way down to the bottom of the door and back up the other side like you see others do, I thought this was a better solution.

http://willyshotrod.com/Willys1246.jpg
So now when I push the door handle button, it lifts the hinge arm up and transfers it to the other side and lifts the lever arm on the latch. The window channel and glass will go in between the hinge arms.

http://willyshotrod.com/Willys1247.jpg
Another top view. With these door handles I could just swap them left to right to make the lever on the inside go up or down to suit. Even just swap the mechanism if needed.

http://willyshotrod.com/Willys1248.jpg
Other door done now as well. These latches can be swapped left to right if it works out better to have the lever at the top or bottom. When like this the lever needs to be pulled up to release, when at the bottom the lever needs to go down.

As with everything in this build thread, you solution to the door latch is pure genius!

Thanks mate. :)