I agree Yom which is why i was so surprised that my dealer here swapped over my draglink and tie rod no questions asked when i had DW and i have 4 inch lift and relocated steering damper and run 35's. I would have understood if they said no so i was very impressed with their service

I put some rubi rock rails on my unlimited sport yesterday. No more stepping over the fat factory steps. Thanks BlueFin!

OK Provent in and a few pics of the Grab handles and sill guards...I know...terribley exciting!! haha
Matt.http://i317.photobucket.com/albums/m...g?t=1260529259http://i317.photobucket.com/albums/m...g?t=1260528953http://i317.photobucket.com/albums/m...g?t=1260529053http://i317.photobucket.com/albums/m...g?t=1260529020http://i317.photobucket.com/albums/m...g?t=1260529171

Grab handle's look good!

I agree, there are waaay better than I thought they would be. Very high quality and mount with both buckles and velcro.

Thanks JeepKonection!!;)

Installed some Off Road Evolution Rock Skins. http://www.offroadevolution.com/stor...=EVO-ROCKSKINS

Haven't seen any available through suppliers here, and these have to be my pick of whats available, they fit under the Factory Rock Rails.
Dealt with Andrew Perle @ Offroad Evolution very professional and prompt service. With Shipping and Exchange Rate they set me back AUS$700.

Must say I was a bit hesitant drilling the first 3/8" hole but then I thought Hell I'm an Aircraft Engineer, I've drilled heaps of holes in aircraft that cost a lot more than a Jeep :rolleyes: But this is my Jeep ;)

The first 4 Holes

http://i299.photobucket.com/albums/m...S/IMG_0001.jpg

Then the Back

http://i299.photobucket.com/albums/m...S/IMG_0002.jpg

Skins back on to drill off front holes.

http://i299.photobucket.com/albums/m...S/IMG_0004.jpg

Front Nutserts installed

http://i299.photobucket.com/albums/m...S/IMG_0005.jpg

Skins Installed

http://i299.photobucket.com/albums/m...S/IMG_0009.jpg

Then Rock Slider Reinstalled.

http://i299.photobucket.com/albums/m...S/IMG_0010.jpg

Why I Did It :p

http://i299.photobucket.com/albums/m...S/IMG_0011.jpg

I wouldn't tackle this job unless you have a proper Nutsert/Rivnut Tool for the job and a bit of confidence in Sheetmetal Work.
Over all I'm really pleased with the end result and must say the skins look Awesome in the Flesh. :cool:

Sarge.

[QUOTE=Macca2801;1030683]OK Provent in and a few pics of the Grab handles and sill guards...I know...terribley exciting!! haha
Matt.

Engine bay looks a bit clean ... def cleaner than mine ... ...

More exciting than the my new plates? "Yes"

Still ..... ordered rear ARB Bar to match the front and "flashpac' ...