Number plate mount
 

6mm alloy plate, an led light and a weekend of cursing to replace the long gone factory relocated mount that was attached with wood screws.

http://i122.photobucket.com/albums/o...1/17032009.jpg

I like it! Something different is always great, especially when you know you have done it yourself! Well done mate!

here it is:

http://www.sydneyjeepclub.com/galler...f57b3a8ebf85e2

4x4 Show was on here at Brisbane, took the opportunity to buy a new UHF and antenna. Did the install this weekend - mounted on the Daystar panel I had bought. Also improvised with the shifter rubber boot, where I broke the plastic guard when I removed the interior for rhino lining... Not bad if I say so myself, $3 worth of silver bolts from Bunnings. Drilled through the original plastic moulded screws which were impossible to take off.

http://i179.photobucket.com/albums/w...s/P1000059.jpg
http://i179.photobucket.com/albums/w...s/P1000060.jpg
http://i179.photobucket.com/albums/w...s/P1000069.jpg
http://i179.photobucket.com/albums/w...s/P1000068.jpg
http://i179.photobucket.com/albums/w...s/P1000065.jpg
http://i179.photobucket.com/albums/w...s/P1000066.jpg
http://i179.photobucket.com/albums/w...s/P1000067.jpg
http://i179.photobucket.com/albums/w...s/P1000071.jpg

I installed the sPOD and replaced the Daystar lower switch panel.....

Extended front and rear diff breathers. Piss of piss, even a dumb ass like me can do it!!

Had a gut full of bending the numberplate on minor trips so fitted the ARB number plate relocation bracket to the spare wheel.

Also went to the 4wd show and got a Magnum winch. Now I have a project for next Saturday :-)

Also ordered a AEV snorkel from Jeepkonnection but not brave enough to fit it. Have a panel beater mate who will do the cutting during the week.