2.7 CRD Fuel Lines & O-Rings Anyone know if the 2.7 CRD fuel line O-rings are replaceable with generic (ie Repco) O-rings?
Are the clips at each end of the lines available in generic form or only from Jeep? Are the replaceable at all or do you have to buy the whole fuel line? I replaced the fuel filter today and in the process of bleeding air from the lines have come across a leak on the upper line on the front of the engine. Most of the clips are old brittle and broken. |
There is a post here somewhere about that same thing but I can't find it.
Anyway the fuel line part numbers are: Filter to Pump : MB A6650700532 Jeep 05080482AA possibly $50 Pump to fuel rail: MB A6120703232 Jeep K05140798AA possibly $120 I haven't got around to researching alternatives connectors yet but will have to as mine need replacing as well, should be reasonably common I think. I have listed other part numbers here; http://www.ausjeepoffroad.com/forum/...d.php?t=124873 Also any fuel rated 'O' ring of the right size would be okay. |
Thanks Drover,
I ran around a the few local stores that were open today and came up with absolutely nothing. In the process of removing the o-ring off the connector I destroyed it (brittle) which indicates it was probably time to replace them anyway. I'll make some phone calls tomorrow on those part numbers you listed and I'll also chase up some o-rings. The O-rings are a square section type not your usual doughnut shape. Jeep sits in the carport until then.. Keep you posted. |
Hi JarradB,
I suppose I better get this as well on mine... I remember Hemi once did this and it improved things out of sight... Any info... photos appreciated of what to get/do Cheers Chumby |
Quote:
|
Quote:
Just curious but when you change the filter you don't have to bleed the lines just fill the filter up with fuel till it comes out the upper bleed screw. Those fuel line connectors are just to dodgy to fiddle with too much I reckon. I've been going to go to a diesel engine shop to see if they have the clips or lines listed, as a normal auto shop like Auto Pro wouldn't. |
Also the o-rings need to be made from vitron rubber not nitrile which is standard for black o-rings, otherwise they swell up go spongey & leak.
|
All times are GMT +10. The time now is 05:59 AM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
AJOR © 2002 - 2024 AUSJEEPOFFROAD.COM. All corporate trademarked names and logos are property of their respective owners. Ausjeepoffroad is in no way associated with DaimlerChrysler Corporation or Fiat Jeep.
www.ausjeep.com www.ausjeep.com.au www.midlifemate.com ausjeepforum.com www.r9kustoms.com