Had a gut full of bending the numberplate on minor trips so fitted the ARB number plate relocation bracket to the spare wheel.

Also went to the 4wd show and got a Magnum winch. Now I have a project for next Saturday :-)

Also ordered a AEV snorkel from Jeepkonnection but not brave enough to fit it. Have a panel beater mate who will do the cutting during the week.

Running a bit late these were done the week before

- sintered bronze filters for diff breathers

- a fire extingisher (for burning jk's :) )

aussiebum what kind of breather are they? is this a new bracker u made also...

The breathers are sintered bronze filters with a 1/4" thread

and the bracket is a 1/4" manifold with 4 inlets/outlets

I got them all from a pneumatic shop near the coburg drive-in

the filters allow air to flow though easily but not water.

most diff breather kits on the market use the little blue air silencers (also from a pneumatic supplier )

the 2 x filters, 2 x 9mm airline stems and manifold cost me under $30.

This is what i've been up to over the last couple of days

http://myweb.westnet.com.au/serinam/Pics/Jeep/Sub.jpg

Just got to carpet it and create some proper anchors/restraints. Just finished this tonight and it pumps HARD!

Yes I built the box myself. It took me 2 days to do it properly but it's a darn side better than the stock sub and it doesn't take up much more room considering the size.

I went for quality gear here as I wanted clean punching bass.

http://myweb.westnet.com.au/serinam/...Spotlights.jpg

Installed the 3 x NARVA Blue 175's on the Rugged Ridge light bar I got from Phil. They're no Lightforce but for the price they are damn good spotlights.

I like it. The 3 lights in the front really look good.

Got some AEV goodness & spotties :D

Attachment 31830