TJ Weld on Panhard Drop
 

Hey guys, I'm still dealing with my bump-steer/wobble issue and think the time's come to drop the front Track bar and Pitman Arm. I've searched the net for a weld on replacement but haven't had any luck for a RHD version.

Does anyone know of anything or do i need to fab one up?

Any advice with doing so?

There aren't really any other options out there apart from the Blackjack one and at over $750 I just can't justify it.

Thanks, Ben

how much lift do you have?

About 5" suspension, their 4.5" R.E. Springs with 1" coil spacers. Both the tie rod ends are wearing way faster then they should and bind way before i run out of down-travel so i'm always worried about snapping one offroad.

iv been looking into this myself and yer the blackjack job it a little out of my price range atm if u wanna do a weld on kit an idea might be to cut off factory mount weld some shs on chassis at required size and weld the bracket back to that may not look pretty but should work fine

http://i294.photobucket.com/albums/m...e/IMG_0067.jpg
Something like this?

thats the sorta thing i was thinking about could mount it on the axle instead for that matter