Jk d44 truetrac
 

Anyone happen to install their truetrac them self?
My research says illd need to get the holes redrilled to 1/2, but i cant find if the gear offset is the same.

The other truetrac ive installed have had the same offset as the stock carriers so the stock shims have been correct, but can't find info about the jk dana 44s

I tried to drill the holes to the next larger size to no available. Nobody I asked could drill them even after trying it. The Truetrac is much harder then any available drill. None of the drills did even scratch the surface of the hardened metal. But it was very nice to see the deeply impressed faces of the workers trying to drill the hole just a little bit larger :D

My workaround was to buy a new set of gears. That workaround involved a lot of new parts and the precise setup of the new gear set.

Not the best news, I guess...https://uploads.tapatalk-cdn.com/201...f34a6c81b9.jpg

Well sounds like an aussie will be the go, then if i regear in a couple of years i can change to a truetrac