|
Driveshaft removal advice I have sourced a genuine driveshaft for the noisy drivers side, I heard they can be a bastard to remove anyone have any tips n tricks
|
I jerry rigged a claw on a slide hammer, made the job much easier for me.
|
Is there anything that needs to be done to pull it out, clips etc or can I just tap it out with a pry bar
|
Not really, the same as any front wheel drive.
Remove the hub and disk assy and disconnect the strut fork. may need to release the lower ball joint so you have enough room to slide the shaft out of the fork. Basically remove anything that may obstruct the shaft removal. |
| All times are GMT +10. The time now is 02:39 PM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
AJOR © 2002 - 2024 AUSJEEPOFFROAD.COM. All corporate trademarked names and logos are property of their respective owners. Ausjeepoffroad is in no way associated with DaimlerChrysler Corporation or Fiat Jeep.
www.ausjeep.com www.ausjeep.com.au www.midlifemate.com ausjeepforum.com www.r9kustoms.com