I FKD around with it until I broke it (quadra-lift) OK, was playing around with my obd tool and looking at how to adjust the ride hight to allow for bigger tires on my 2013 WK2.
Now, the air suspension no longer works and its telling me "Immidiate air suspension maintenance/ repair required" and it's throwing a code. C156E: Air Suspension Height Sensor Not Calibrated. This happened when i went into the "write suspension hight values" setting, but then didn't actually write any hights in there (I'm thinking it set them to 0 and has thrown everything out), So, my questions are as follows. 1. Has anyone else done this before and since fixed it, if so, how?? 2. Does anyone know what the standard ride hight settings are for quadra-lift suspension (I'm thinking, if i punch these hights back in, it will fix the issue), I've searched the net, but cannot find these values anywhere? Thanks in advance guys.. Sent from my SM-G960F using Tapatalk |
Have you tried clearing the codes?
|
Quote:
Sent from my SM-G960F using Tapatalk |
|
Does it have provision to enter the ride heights for the OR1 & OR 2 positions?
My 2015 owners manual lists OR1 as being approx 1.1”/28mm higher. OR2 is approx 2.2”/55mm higher so it looks like it may need the measurement in inches. Cheers |
Quote:
|
Quote:
Sent from my SM-G960F using Tapatalk |
All times are GMT +10. The time now is 12:39 PM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
AJOR © 2002 - 2024 AUSJEEPOFFROAD.COM. All corporate trademarked names and logos are property of their respective owners. Ausjeepoffroad is in no way associated with DaimlerChrysler Corporation or Fiat Jeep.
www.ausjeep.com www.ausjeep.com.au www.midlifemate.com ausjeepforum.com www.r9kustoms.com