I trawled the net to find a good place to mount my ARB Compressor and I have seen some really creative uses of space including under the bonnet, in behind the rear tail light, under the floor near the fuel pump and under the drivers or passenger seat, I am quite surprised just how HOT the pump gets - I would say the heat was extreme - I certainly cannot touch the pump after only filling 1x 33' mtz from 12 - 32psi - given this crazy amount of heat the ARB pump generates I rulled out under the bonnet and in behind the rear tail light and perhaps even under the seats! - plus the real-estate inside my 2dr is very expensive and i do not wish to use the under seat area for a compressor plus I would worry about the heat that would build up and maybe cause a fire!
So after much searching I decided to use the space inside my spare tyre!
here's the write up I did.
1. - install 40amp auto circuit breaker close to the battery
2. - remove spare wheel
3. - run cables in behind rear door trim
4. - install 40amp relay in behind 3rd brake light
5. - install on off switch
6. - Mount compressor
7. - Connect all wires and reinstall spare wheel
Enjoy using your compressor with lots of natural airflow!
Cheers Hunty
