Pulled the front end apart to swap the front springs around as I am trying to combat the uneven settling of my 3.5 RE lift kit.
Well, I removed the springs and placed them alongside each other while I measured each of the springs whilst unladen. They were the same, however I managed to forget which was which as complacently forgot to mark which spring came from which side.
So, I took a punt and reinstalled everything hoping I had got it right. Upon initial measurement there seemed to be an improvement though after half an hour of settlement it had returned to its uneven origin.
Now, wondering if I should have another go and remember to mark the springs or just put a spacer in the the drivers side to even it up. There is an inch difference between the left and right in the front end.