I first made sure that I had all the bits I needed to glue, cut, insulate, cover etc etc so here is a list of things
Sikaflex 227
Heat resistant black paint
18volt drill which meant it wouldn't kick out on me like a power drill would as I could set the clutch on it.. Learned that one out the hard way with my previous jeep as the power drill kicked out on two of us holding the damn thing and it cut the aircon pipe.. I also had a small angle grinder with a cutting wheel... A dremel or a drill nibbler would do the job too
You need a hole saw drill bit I think it was a 45mm hole saw bit (it is specified in the instructions)
And tape to stop paint chopping when cutting and to stop over spray, I used the blue stuff from bunnings
You'll also need a 12mm spanner or long reach socket and the right sized allan key. You'll need a T40 torx bit to get the body pannel bolts out...
Sent from my iPhone using Tapatalk