Noise rear shocks
This has driven me mad bolts in bolts out new washers big ones small ones. I have even had two dud Rancho Shocks. I found Removing the welded nut on the lower mount two washers either side of crush tube and as suggested tightening on the Ground with long bar helped on the drivers side rear but still working on passenger side rear Drovers suggestion of the right size bolt to fit the crush tube is a very good idea and a longer crush tubes. According to 4wd1
the bottom rear mount when compressed only touches the rubber and not rhe crush tube hence the rattle. I still trying to find the right solution so any more suggestions would be most welcome.
|