AUSJEEPOFFROAD.COM Jeep News Australia and New Zealand - View Single Post - UHF Antenna Install
Thread: UHF Antenna Install
View Single Post
  #4  
Old 13-05-2014
mowerman's Avatar
mowerman  mowerman is offline
Established Member
  
Join Date: May 2005
Location: Woodford, Blue Mountains
Posts: 148
Likes: 0
Liked 9 Times in 5 Posts
Default UHF Antenna Install
The piece on the bullbar looks like the end of coaxial and might easily take an antenna/ spring. I have a GME antenna which has the large screw in arrangement much bigger than the one shown. If in doubt just get a new antenna on place like eBay and re do it. It's easy enough. Run the cable through the firewall on the passenger side high up under the plenum chamber. You take the side panel off the dash, it just un clips. Then there is a cast alloy bracket and a bit space foam and you can push a screwdriver straight though the space foam and it comes out above the guard. You can then attached the cable to the screwdriver and pull it back through to the inside. Sorry I don't have any pics.