Quote:
Originally Posted by JarrardB
Arb bar lines up perfectly so no need to trim... If I went 33" or bigger I might consider cutting off the lower 'triangle' section. Not planning on doing anything to blend the bar to the width at the moment. Its actually not that obvious in the flesh and the thought of having to re paint the bar ism't a pleasant one. What is bugging me at the moment is the white section where the mudflaps normally are as it now stands out like dogs balls. I might mask it up an inch or so from the edge and slap some black on it.
|
Ok, looked like the bar had been trimmed back before but must be the angle of the shot. Same with the width, it doesn't look as different from the front, must be the shadow. Looks good.
At 2.5" lift mine still scrubs the back edge of the bar just a little bit.