I have some washers I wanted to use as front clevis spacers, and these are 6mm each. The TJM lift is meant to give me 30mm to 40mm in the front (over stock).
The TJM spring is rated at 460.
The TJM kit also includes a 5 mm and 10 mm spacer that go just below the spring.
I was going to use 12mm clevis spacers on each side for the front, which should give me about 18mm to 20mm total lift. This should net me around 50mm to 60mm total lift in the front.
I was also contemplating whether I should use the small 5mm TJM spacer, but worried it might be too high and cause issues with the stock UCA (brand new).
What do you think ?
Last edited by KJ75; 04-04-2016 at 03:48 PM.
|