It's been a slow couple of weeks due to work and study but made a little progress before the rain set in.. started cutting the floor board notch for the transfer case. There's a pressed sheet steel 'cross-member' of sorts that the front seats front mounts bolt too which increases strength a lot but it's also in the way so some of it had to go. I'll tidy up the cuts once the rain buggers off and cover the hole with the 1.5mm chromoly sheet. It'll be just as strong and give better belly clearance. Always hurts making the first cut in undamaged panels. Got the front panhard sorted and the rear lower control arms. Waiting on the 7/8 heims for the rear panhard
|