Quote:
Originally Posted by layback40
Do a Facebook search for the VM group.
I still think you have an issue with it. Maybe there is a break in the wire some where. You should be able to go right back to the EMU behind the heater inside the jeep & make sure you have conductivity there. Everything you are posting is saying limp mode.
|
Thank you
You're probably right, darn it...
I did measure the loom and looks ok as per amlav prior established values at 7.2kohm
Unfortunately I gave up Facebook a while back - asked gf to have a looksie, only been able to find the original page and group of the VM manufacturer.
I'll have a closer scan. Thank you for the tip
R