You have a very server pinion angle. Hard to see the amount of caster in the photo. From what you say, it sounds excessive. If this axle is suited to 4+ they will have built in additional caster. Personally, I'd be trying to at least half that pinion angle - it should almost look straight with the driveshaft. That will bring the caster down at the same time and correct your spring perchs.
As a rule of thumb, you want the pinion angle as close to 0 as possible without sacrificing too much caster. If this axle has 10 degrees caster built in (like my dynatrac has) you should be able to achieve 4.5 degree caster and very little pinion angle.
Sent from my SM-G930F using Tapatalk
|