The better resonator came in but I ended up ordering the wrong one somehow! I was after the 5" round and got the 4" round, so hope it will still workout alright.
As you could see from the last photo is is a lot longer so going to be a tight squeeze to fit in between the last bend past the shock absorber and the bumper. So cut the length down as much as I could. The 3" 45 degree bend finally came in too to make the exhaust tip from.
TIG welded the 45 degree bend on.
Think it is a touch long!
The length makes it easier to line everything up and also decide the final length.
Can see the stainless has already started to change colour from the exhaust heat compared to the new muffler and tip.
Hanger was cut off and welded onto the new muffler.
I prefer the bend cut this way rather than the full droop version I had on before.
Didn't want the 'ricer' look so think this is nice a subtle.
