2007 WH CRD - no DPF, Swirlpot mod and egr mod done.
Engine will crank, fire then shut off in 2 seconds, and the oil lamp comes on.
This happened after the engine went into limp mode driving home today. The engine had no power, could hardly move, max speed of 30kph and was surging.
Scan showed P0471 - exhaust pressure sensor, however this should put it into limp mode, not present the above symptoms as far as I am aware. I have removed the sensor, inspected it and replaced it.
Any advice re the nil start issue would be great. At this point, even if I install a new sensor, I can't run the engine to test if that is fixed.
There is plenty of oil in the engine.
|