Thought it was a good time for the engineer to come out and inspect the Willys in person for the first time. I had been in contact right at the start of the build when I was making sure I could do this project and get full registration at the end of it. So he had followed the build on my website and knew how everything was done. I still wanted him to see it though before I started with interior trim so he could inspect seat belt, seat, steering column mounts etc. before they are covered up.
Well he couldn't find a single thing wrong!
Certainly was made easier using everything from the one donor because all compatible and that it also had a higher kerb weight than the Willys.
He said fully assemble it and do some testing miles on it on a unregistered vehicle permit,
https://www.vicroads.vic.gov.au/regi...ehicle-permits, and then he will finish checking everything that is not fitted yet and do a driveability test etc.
Best outcome I could have hoped for.