Limp Mode Crankshaft Sensor
Hi All
My 2015 Overland diesel went into limp mode as i was towing a 3 tonne trailer down a steep hill, traffic was moving slowly so i put car in 2ng gear to use the engine braking.
Got the usual lights, engine,throttle control,service 4wd,service air suspension.
Towed home and used my scan tool, got a few error codes main one Crankshaft position sensor, i think other codes are because on the crankshaft one.
How hard is it to swap out, looked on Utube but could not find anything useful. IE wrong series or different engine.
Have the car booked in with Jeep to replace a head rest that deployed while driving, should i get them to do it.
Thanks
Last edited by orbital70; 14-04-2024 at 03:01 PM.
|