jk07 my computer knowledge is limited, don't know how. but the slave cylinder is on the passenger side of the bell housing, visible from underneath.there is a short line from the cylinder to a bracket , and then a rubber fluid line going up and around the bell housing, up to the top of the bell housing where it becomes a metal line agian. if you climb under the passenger side (it's only visible from there) and run your hand along the hose up and around the bell housing (where it isn't visible) you can feel if there is any wear. do it when the exhaust is cold as the pipe runs close by. i burnt my hand playing with it. probably a bit of that split plastic tubing all the wiring harnesses are covered in would do the trick.
|