Just had a look at the manual & this is all I can find about it. You are correct the ecm is recieving the wrong type of gearbox signal or the ecm is faulty.
Cheers
Bri
P0610-AUTOMATIC TRANSMISSION CODED AS MANUAL TRANSMISSION
For a complete wiring diagram Refer to Section 8W
² When Monitored:
With the ignition on.
² Set Condition:
The ECM detects an automatic transmission when it has been programmed for a manual transmission.
Possible Causes
ENGINE CONTROL MODULE
VERIFY ECM PROGRAMMING
Diagnostic Test
1. VERIFY ECM PROGRAMMING
Turn the Ignition on.
With the scan tool, erase the ECM DTCs.
With the scan tool, verify that the ECM is properly coded for the options and components that the vehicle is
equipped with.
NOTE: Reprogram the ECM with correct information if necessary.
Start and idle the engine.
With the scan tool, read ECM DTCs.
Did this DTC set again?
Yes >> Replace and program the Engine Control Module in accordance with the Service Information.
Perform the ECM Verification Test Ver. 1 (Refer to 9 - ENGINE - DIAGNOSIS AND TESTING).
No >> Test complete.
Perform the ECM Verification Test Ver. 1 (Refer to 9 - ENGINE - DIAGNOSIS AND TESTING).
P0610-MANUAL TRANSMISSION CODED AS AUTOMATIC TRANSMISSION
For a complete wiring diagram Refer to Section 8W
² When Monitored:
With the ignition on.
² Set Condition:
The ECM detects an automatic transmission when it has been programmed for a manual transmission.
Possible Causes
ENGINE CONTROL MODULE
VERIFY ECM PROGRAMMING
Diagnostic Test
1. VERIFY ECM PROGRAMMING
Turn the Ignition on.
With the scan tool, erase the ECM DTCs.
With the scan tool, verify that the ECM is properly coded for the options and components that the vehicle is
equipped with.
NOTE: Reprogram the ECM with correct information if necessary.
Start and idle the engine.
With the scan tool, read ECM DTCs.
Did this DTC set again?
Yes >> Replace and program the Engine Control Module in accordance with the Service Information.
Perform the ECM Verification Test Ver. 1 (Refer to 9 - ENGINE - DIAGNOSIS AND TESTING).
No >> Test complete.
Perform the ECM Verification Test Ver. 1 (Refer to 9 - ENGINE - DIAGNOSIS AND TESTING).
__________________
My toy: 97 TJ Wrangler
Her Toy: 2003 Mazda MX5
Our toy: 2007 KJ Cherokee
|