The R is not always printed into the fin area, don't worry too much about it. It has to do with rotation direction, which is different in the different setups.
Just verify if the fin "direction" (or orientation) is the same as the original wp, and you should be ok.
I'd buy a decent brand, because you don't want some cheap stuff make you have to do the job again in two years.
Mine was Omix Ada, which is really a US MotorWorks sourced wp. Have a look on Rockauto and the likes, a good wp should not cost you an arm and leg
__________________
97 XJ 4.0 Sport (Nov)
Chrysler 8.25"
189.000 km
Stop calling your car a "she". It's a car.
Last edited by Roler; 04-05-2015 at 01:07 AM.
|