Fuel pump bracket made
Fitted and hidden out of sight behind the Shock and between the tank
Fuel line from tank
Regular mounted, plumbed to carby with 1/8 fitting for gauge
Coil mounted and leads done
Battery cable ran
Through the wheel arch
Out and into the battery box
Battery boxes mounted
Roof lining fitted
Rear doors done, I ended up painting the ash tray seduce lol
New door handle gaskets finally turned up from the states
Then....
Tried to fit the radiator. Must be a difference between the 6cyl front aprons compared to the V8s. Tried to fit the V8 radiator to find it was wayyy off from fitting.
Almost ready to slam the shed shut and come back after my wedding I bit the bullet and got the grinder out and decided to make my alloy Falcon one fit.
Came up alright, had to cut the support brackets out but I welded some bracing back in on the inside.
Upside, it will stay cool as with this rad, as before hammering through soft sand it use to creep up quite easy.
Anyway, got my dash back. I welded it all up and my panel beater glassed and smoothed it. Turned out well..
Before
After!
Only bad thing, he left the jeep cherokee sticker there :scratch: he offered to repaint it but time is running low, so I stuck an autometer sticker over it
Grill is back now too all repainted
Seats, carpet and shifter fitted
Dash fitted
