Hi deezel ..
Thanks for you advices!
Curiously the franm oil filters here in brazil is recognized as excellent filters . What you think about bosh filters ?
Again about air turbulences on the bumper hole, i agree with you , but is better than notting, or not?
Yes , you are correct again, my pressurre drops a little bit. In cold start before cooler installation was 5~6 bar and with engine hot was 3 bar at idle . After cooler cold start drops for 4~4.5bar and warm is 2.5 bar at idle .
At 2000rpm pressure are 4bar with engine warm at 95°C. I checked the service manual and this pressures are inside of the tolerance range . Am i correct ?
I will to change the hose clamps for another with best gripe/clamping design ( or even crimps design like as you says ). The hoses are the best as i could found , good quality, for oil , high temps resistente and handles 10 bar pressures . Are not enough?
Regards
|