AUSJEEPOFFROAD.COM Jeep News Australia and New Zealand - View Single Post - Safety Recall N23 for WH anyone had it done yet?
View Single Post
  #8  
Old 30-09-2013
JamesLaugesen  JamesLaugesen is offline
Full Flexer
 
Join Date: Jan 2012
Location: Hills District, Sydney
Age: 40
Posts: 874
Likes: 34
Liked 130 Times in 96 Posts
Default

I'm still a bit reluctant, mainly just because my local dealer has been rubbish in the past, and I don't have the time to risk dealing with them atm.

Quote:
Originally Posted by Doc View Post
did throw the usuall 0652 code twice have given up on that one just waiting for whatever it is to die can't justify taking guesses dealership had no idea
I assume you've pulled the code up?
It's almost definitely a short/bad circuit somewhere considering your other issues, and could even explain the whole lot.
Most mechanics and auto-elecs are only any good at interpreting the codes literally... so more-often-than-not it's gunna be hit-and-miss with electrical stuff.

If you somehow get motivated later, do another check over all the wiring looking for rubbing, especially for the stuff below;

P0652-SENSOR REFERENCE VOLTAGE 2 CIRCUIT LOW
Possible Causes
INTERMITTENT DTC
5-VOLT SUPPLY CIRCUIT SHORTED TO GROUND
CRANKSHAFT POSITION SENSOR
BOOST PRESSURE SENSOR
FUEL PRESSURE SENSOR
ENGINE CONTROL MODULE