AUSJEEPOFFROAD.COM Jeep News Australia and New Zealand - View Single Post - XJ indicator issues
View Single Post
  #4  
Old 05-02-2018
jaffazoom  jaffazoom is offline
Established Member
 
Join Date: Dec 2014
Location: Qld
Posts: 189
Likes: 0
Liked 97 Times in 56 Posts
Default flashers

looks like the flashers and hazards share same flasher can going by the wiring diagram.
The flasher can does have 2 outputs though, one for hazards one for flashers.
If it's a bad connection in the combination switch try working the hazard switch off on a few times and see if that helps if not your probably up for a flasher can. I haven't looked at mine but the wiring diagram shows its a 5 pin so not your old school type.
Sponsored Posts