23-06-2016
|
 |
MonsterMoose
|
|
Join Date: Nov 2003
Location: Brisbane, Southside
Age: 51
Posts: 10,539
Likes: 369
Liked 1,110 Times in 691 Posts
|
|
Quote:
Originally Posted by alexbrown64
Well, i played around all day. Used tungsten carbide burs, cobalt drill bits, 3/8 x 16 UNC tap, etc.. cost a fortune.. old stud all drilled out, and i ended up with a threaded hole that is too sloppy. My last resort is a Recoil 23603 3/8 x16 UNC thread repair kit. It has a short shank drill bit that i can fit in, and then rethread to correct dimensions for coil and then stud. I was toying with the idea of Devcon and all that, but it would just be a bodge job.. i am hoping for everlasting peace when this is done.....  |
Again, sounds familiar....
__________________
JJ
Do it once, Do it right!
2014 WK2 Overland
|