Fixed up my DRL lights. Off:
On:
FYI I found switched power from unlabelled fuse M14.
Installed Rugged Ridge LCA skid plates. Front:
Rear:
The front was easy enough but it was an exercise in patience because it was a struggle to line up and keep picking up each of the 4 washers that go on each side. At least I discovered that the passenger LCA bolt on the frame side was dangerously loose.
The driver side rear skid was a 15 minute job but the passenger side needed a mallet and bfh to get on and after 40 minutes of hammering, I had to jack the wheel up to get the bolt hole on the arm and axle to line up.
Speaking of rear, I decided to test my luck in the festive season roadblocks by removing the rear bar corner pods:
Lukadatsaxyess!