AUSJEEPOFFROAD.COM Jeep News Australia and New Zealand - View Single Post - push start a jk
Thread: push start a jk
View Single Post
  #6  
Old 28-01-2014
JKlamb's Avatar
JKlamb  JKlamb is offline
Established Member
  
Join Date: Jun 2012
Posts: 165
Likes: 11
Liked 13 Times in 7 Posts
Default push start a jk
Modem cars need an approx minimum of 5.5 volts to run the ECU (engine control module) this controls the ignition timing and fuel injection. So even if you clutch it, unless these parameters are meet voltage wise it will not start.