Pesonally I'm not too keen on the tubed design.
Over time I'll be looking to put basically a flat plate as the skid.
But the biggest issues I can find are:
1. To get it dead flat I'll need a 2" MML (I currently have none).
2. A dead flat skid has the same effect as an additionaly 2½" suspension lift....ie 7" on my TJ - and I'll probably need new shafts to be able to cater for this.
3. I'll probably get a new exhaust at the same time (I need one anyway
).
4. The folds in the stock plate generate much of it's strength - IMHO you'd want thicker than ¼" - I was thinking 5/16" or even as much as 3/8" - but then weight becomes bit of an issue.
5. The other conceren I have if the negative effect on the CoG - as it's lifting some of the heviest components
Still thinking.....