AUSJEEPOFFROAD.COM Jeep News Australia and New Zealand - View Single Post - Cutting the Hardtop
View Single Post
  #1  
Old 21-05-2017
RedPig  RedPig is offline
I just registered
 
Join Date: Apr 2017
Location: Gold Coast
Posts: 8
Likes: 0
Liked 1 Time in 1 Post
Default Cutting the Hardtop

Ok, so I'm cutting the Hardtop in half to make it shorter... Basically I'm going to cut the middle part out and join the back onto the front... It will be about 500mm long...



http://imgur.com/JzJFLB7

That's done now, no problems there..

http://imgur.com/V7usOjY



I was thinking of making the back part two pieces and join it around the roll bar... You can see in the following picture I've marked where the roll bars come out... Problem I'm having before I continue is on the right side where the wires go through to the window... Is it possible to remove the wires inside?



http://imgur.com/7xKH2Ik

It looks as is they're going to pass right through where the hole for the roll bar is going to be...

Any suggestions? Can I remove the wires in there somehow?


EDIT: Why arn't the pictures showing...?

Last edited by RedPig; 21-05-2017 at 10:23 AM.

Sponsored Posts