[08crd]

I made mine out of old bed frame angle, I'm more of a metal worker, than wood. Basically the whole perimeter is angle, with feet to lift it level with the load lip. Then a divider to suit the fridge slide welded in.

The back legs bolt directly into the rear seat mounts and the front are attached with threaded u bolt to the front seat clips.

The floor panel on the right slides into a bracket at the front and two large bolts at the back. So it is easy to remove, to access the gear underneath.

It has worked well for me, hope my explanation helps, it is a bit rushed. I could supply measurements, but that would mean pulling everything out and I'm a bit busy ATM. lol