Quote:
Originally Posted by mud_slut
pulled the rad and the intercooler out for a clean. reverse flushed all the gunk out of the heater core and snapped one of the bolts on the thermostat housing, to pb blast, weld or ezy out, not sure which one i will try first
|
its too thin to use an easyout. If there is a stub sticking out, vice grips may be good. 50/50 acetone (nail polish remover) & atf is the best anti seize for this. A bit of heat from a butane torch helps. Be careful not to over heat the alloy though. If no luck, the 3 remaining bolts should be more than enough. Use plenty of silicone when you put it back together & anti seize paste like copperkote or the ally one would be better.
Good Luck !
__________________
98&01XJVMs,06&07KJCRD's,No longer question authority,I annoy it.More effect,less effort.10000Club
|