Auto Trans: Jeep W5J400 MB: W5A580 Spec:MB 722.6)
Jeep....Gasket.................5210833
Jeep....Filter....................52108325AA
MB......Filter with gasket.*................1402770095 S1
Mann Kit........................H182
Ryco....................RTK92 ..........note: check it's the right one as RYCO listing was incorrect.
Conductor Plate...........Jeep....52108308AA.............MB. ....140 270 11 61
Video about the 722.6 tranny..................…..
Auto Oil: (Jeep W5J400...MB.. W5A580 MB722.6
MB.*................001 989 21 03 (spec 236.10 )
Shell..............SPIRAX S4 ATF 3403 (haven't found any)
MB upgraded spec to 236.14 following meets that spec by MB.
Fuchs TITAN ATF 4134
Mobil ATF 134
Shell ATF134
Shell SPIRAX S6 ATF 134M
Valvoline SYNPOWER ATF 134
While the ATF134 is specced, not available in Australia.
Check oil company Lube Guides but confirm the
MB spec 236.10 or 236.14 some are incorrect with ref for the 2.7. if it has the MB spec it is okay.
Penrite
multi vehicle full syn ATF and MV semi-syn ATF meet 236.10
Fusch ATF134 available at Don Kyatts, Darwin,, so might be found elsewhere.
Do not use ATF+4 in this box.
Transfer Case Oil:
* MobilFluid 424............about 2lts per change. (Mopar fluid is 10x the price and believe 424 is the same stuff)
http://www.eclubes.com.au/products/v...mobilfluid-424
Drive Shafts:
The front drive shaft has replacable bearings.
Front shaft rear bearing: hardy-spicer CV-861 (same as on a BA XR8
Front shaft front bearing: TBA
Whilst all care has been taken to confirm these numbers the onus is on you to double check.