Hello all been awhile since being on here but I have a sensor fault showing up
P061B
Internal control module torque calculation performance
The engine light just comes on, then when you check it using my FIXD device it shows this code but when you turn the car off then back on the fault is gone even on the scanner until next time.
Is this a big issue as I will be towing a large trailer in two weeks.
How to fix would be good don’t trust Jeep here and my local mechanic does not know a lot about Jeep
Mines a diesel 103,000k up till today replaced MAP sensor as it was faulty.
Have a catch can plus a stainless turbo muffler newly installed.
No big issues till this.
|