Quote:
Originally Posted by samft
Hey Guys
2010 CRD here
I have 2 optimas linked up in a dual battery system.
Is there a way to set the alternator to the 14.3 volts default output by unplugging something?
I have relocated both batteries to the rear of the Jeep so I'm not worried about temps.
I usually see 13.9v - 14.2v on my scangauge and would like a bit more juice
EugeJK - I read your post, where is the connector that you unplugged?
|
It's on the alternator, 3-pin connector with 1 active wire. Mine defaulted to 14.2-14.3V once I disconnected it. But you'll get battery warning light as the ECM senses it no more.