[Gildo]

Gents, I'm keen to swap over the old keyless entry to radio control rather than the existing IR on my 1996 XJ.
The remote kit is simple enough, purchased off eBay now I just need the pinouts on the factory wiring.
I've seen the YouTube vids but none so far match the wiring colours that I have.
Two possible locations for the new receiver are:
1: in the original location in the roof
2: under the dash/ behind the DS kick panel
I have some guesses from other re-wiring so far.
Existing colours on the PCB connector are
1: Pink ( Guessing = 12v power+?)
2: N/C
3: Orange/Violet
4: Pink/Violet
5: Blue/Orange
6: N/C
7: N/C
8:White/Black
9: N/C
10: Black. (Guessing = battery ground/ -?)
11: N/C
12:Yellow. (Guesding = Interior lights?)

I'm assuming I only need +,-, lock & unlock for it to function correctly, with the horn, indicators and interior lights being extras if I want to add them.

Has anyone done this?
What are the pinouts?
Any links would be helpful too.