[awg]

Originally Posted by HamishW96

I had the rear driveshaft out not long ago, the uni felt good. Can the front one cause similar issues?

Also I have messed with the gearbox mount. Does anyone know the distance between the TC and their bash plate?

Also as my diff is shit, could it be a worn pinion causing bad vibration?

Thanks.

did you mark & keep rear driveshaft in same orientation during R&R ?

apparently the trans space is ~1", mine is a bit less from age, needs replacing

I doubt a worn pinion bearing would cause vibration unless it was terminal, is there excessive freeplay...like 1/4"?..would be awful noisy

mine vibrates a bit at ~90-95kmph (it needs a wheel alignment)

the trackbar joints can be worn

I would start with the basics things