Quote:
Originally Posted by XJKEE
Ok this one is on from Carves back in the dark ages when this thread started.
As per the book ... ya lazy sod ...
OIL PUMP VOLUME CHECK
After the new or repaired transmission has been installed, fill to the proper level with Mopart ATF PLUS 3 (Type 7176) automatic transmission fluid. The volume should be checked using the following procedure:
(1) Disconnect the From cooler line at the transmission and place a collecting container under the disconnected line.
CAUTION: With the fluid set at the proper level, fluid collection should not exceed (1) quart or internal damage to the transmission may occur.
(2) Run the engine at curb idle speed , with the shift selector in neutral.
(3) If fluid flow is intermittent or it takes more than 20 seconds to collect one quart of ATF PLUS 3, disconnect the To Cooler line at the transaxle.
(4) Refill the transaxle to proper level and recheck pump volume.
(5) If flow is found to be within acceptable limits, replace the cooler. Then fill transmission to the proper level, using Mopart ATF PLUS 3 (Type 7176)
automatic transmission fluid.
(6) If fluid flow is still found to be inadequate, check the line pressure using the Transaxle Hydraulic Pressure Test procedure.
--------------------------------------------------------------------------------
|
I found the 1 quart per 20 sec at idle but i'm buggered if I could find the transaxle in my XJ 1996. I'll keep looking and get back to you as soon as I find it.
How much oil flow at high idle. If I have to I'll do a oil volume at high idle but I'm expecting a bath in ATF. Just hoping some one knows. I'm curious as to how much increase in flow there is at normal operating RPM's