The whole lot is a pisstake, all the photos are photo shopped. The specs state it has two 9" diff and running CV driveshafts, look at the rear diff hub compared to the intermediate diff hub... notice the difference?
There is no way you could power divide beween to axles that close together and if they are running a tripple output t/case they dont mention it!
It a joke for sure! Check the website, its just photoshops and no detail whatsoever! At best its just one prototype with a stretched chassis, 6x4 with a lazy rear axle, but I doubt they have even done that...
Looks more like a training project for a art or computer design course or just a shonky promo for WildBoar products!!
Matt.
edit**
Yep looks like ONE vehicle has been done,
Cut from the JK6 website,
Front Differential: Modified Dana with RCV Axles
Rear Differentials: Currie Ford 9" rear ends with Eatons coupled with CV drive shaft
Cut from the wildboar website:
3.6L V6 Engine with 285 HP and 260 lb-ft of Torque
6-Speed Manual Transmission,
Dana® Front and Rear Axles, 6X6
Total fuel capacity 65gal. 1000 + mile range without refueling
Seven Toyo Open Country MT's 35x12.50 R17 with Method
Race Rims 17x9 Bead lock with bronze powder coat
Power Heated Exterior Mirrors, Tubular Side Steps, Leather Interior
SiriusXM Satellite Radio Seven Infinity® Speaker with Subwoofer