Quote:
Originally Posted by Rosie
Carvs: Whats the point of that link?
|
4 x 40mm shs vertical uprights with the tops drilled and each have a horizontal piece of 10mm I.D. tube welded in.
Crossbars have drilled, 5mm tabs welded on at the ends 41mm apart to fit either side of the vertical shs.
One pin ( displayed in link ) through the horizontal tube in the upright and crossbar tabs acts a hinge ... allows you flip it from either side.
Bigger and different types available .... at any good tractor shop
Just one way of doing things.